Positioning The Logs; Connecting To The Gas Supply; Operating Instructions; Lighting - Dru DIABLO Instructions D'installation

INSTRUCTIONS FOR INSTALLATION

Positioning the logs

• Place the largest log against the back wall.
• Sprinkle the vermiculite evenly over the burner tray and the
surrounding tray, (the vermiculite tray).The vermiculite is
• Sprinkle the yellow chips on top of the vermiculite to
create a glowing effect on the burner bed.The chips is in a
plastic bag with the logs.
• NB: do not sprinkle any chips on the mesh over the hole
above the burner tray as this could distort the flames.
• Make sure that no vermiculite gets on or into the pilot
light burner.
• Now position the rest of the logs as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been manu-
factured specifically for this appliance.

Connecting to the gas supply

Connect the gas supply to the gas control valve with 3/8"
inner thread.
In the connecting pipe an approved connecting gas tap
with a coupling should be included. This should be placed
outside the casing.

OPERATING INSTRUCTIONS

fig. 5
Furthermore please note that:
• Expel all air from the supply pipe before coupling the
appliance.
• Do not turn the control tap when connecting the gas
supply.
• Avoid any tension on the control tap or pipes.
• Check that the connection is gastight.
OPERATING INSTRUCTIONS
The control buttons are located behind the flap at the
bottom of the heater front.

Lighting

Press button A and turn to the left to the small flame
The flame will ignite at
behind the glass is alight. If that is the case, hold button A
firmly pressed for another 5 seconds. Then release button A
and check that the pilot light is still burning. Now turn
10
fig. 7
. Check that the pilot light
.