Foreword; Unpacking; Connection; Important - Dru ROMANO Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered
installer.

Important

• Ensure that at least 3 m. (vertical) outlet pipe, 100 mm
diameter, is connected to the appliance.
• It is not allowed to wrap a built in appliance in any kind of
isolation material.
• Before you start using your fire, it is wise to clean the glass
front.This to prevent burning in of possible dirt into the glass.
INSTRUCTIONS FOR INSTALLATION

Gas type

This appliance can only be used and is only suitable for the
country and the type of gas mentioned on the type
identification tag.The manufacturer (DRU) has adjusted
the appliance so that it is suitable for G20 (20 mbar).
Check that the local gas type and pressure correspond
with the specifications on the gas type plate.The type plate
is on the inside of the casing. All regulations applicable for
gas installation, including any locally enforced regulations,
should be observed at all times.The appliance must be
connected by a qualified installer.
If the appliance is to work on G25, please follow the
instructions elsewhere in this booklet.
For the appliance to work on propane (G31) it will have
to be converted by a qualified installer.
A conversion set can be ordered through him.
Important
• Make sure that any curtains or other combustible
materials are at least 50 cm away from the heater.
• Beware! Touching hot parts of the heater can cause burns
and blisters!
• The appliance must be installed by a qualified fitter
• DO NOT use a dust filter under or on top of the casing.
• DO NOT hang wet clothes or towels etc. on the heater
to dry!

Conditions of installation

It is the law that all gas appliances are installed only by a
CORGI Registered Installer, in accordance with these
install appliances correctly could lead to prosecution. It is
in your own interest and that of safety to comply with
the law.
The installation must also be in accordance with all
relevant parts of the Local and National Building
Regulations where appropriate, the Building Regulations
(Scotland Consolidation) issued by the Scottish
Development Department , and all applicable requirements
of the following British Standard Code of Practice.
• B.S. 6891 Installation of Gas Pipework
• B.S. 5440 Parts 1 & 2 Installation of Flues and Ventilation
• B.S. 1251 Open fire place components
• B.S. 715 Metal flue pipes for gas appliances
• B.S. 6461 Part 1 installation of chimneys and flues
No additional ventilation is required for this appliance.

Positioning

• This appliance must be installed in accordance with the
current regulations and may only be used in a properly
ventilated room, to ensure that there is always sufficient
air supply.
• The appliance may only be installed against a wall made of
combustible material if the wall is protected with a
protective panel.
• Keep the connection between the pipe mouth and the
chimney duct as short and straight as possible. The gas
control block must be easily accessible.
• The minimum height of the chimney duct is 3 mtr.
• At least 3 metres of 100 mm ø (vertical) duct should be
connected to the appliance.
• It is not allowed to wrap a built in appliance in any kind of
isolation material.
14