Foreword; Unpacking; Connection; Instructions For Installation - Dru Alto Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered
installer.
INSTRUCTIONS FOR INSTALLATION

Gas type

This appliance can only be used and is only suitable for
the country and the type of gas mentioned on the type
identification tag. Check that the local gas type and
pressure correspond with the specifications on the gas
type plate. The type plate is on the inside of the casing.
All regulations applicable for gas installation, including
any locally enforced regulations, should be observed at
all times. The appliance must be connected by a qualified
installer.

Reconstruction to different type of gas

If you want to convert this appliance into a different
type of gas, please contact DRU's service department
and ask what is possible. Reconstructions should only be
performed by authorized gas installers.

Important

• Make sure that any curtains or other combustible
materials are at least 50 cm away from the heater.
• Beware! Touching hot parts of the heater can cause
burns and blisters!
• The appliance must be installed by a qualified fitter.
• DO NOT use a dust filter under or on top of the casing.
• DO NOT hang wet clothes or towels etc. on the heater
to dry!
• NB: To ensure the ignition works properly, the ignition
wire must come into as little contact as possible with
the metal parts of the heater and should therefore
not be wound round the gas or pilot-light pipes or the
thermocouple
fig. 3
38C-1033
18
Important
Top
awing line
awing line
Outlet