Lighting The Heater For The First Time; Extra Protection; Disposal; Guarantee - Dru Alto Instructions D'installation Et Mode D'emploi

Use candles and oil lamps as little as possible, keeping
the wick as short as possible. While they Enhance
the atmosphere, candles and oil lamps also cause the
formation of large quantities of unhealthy soot particles in
your home. Cigarette and cigar smoke contains tar, which
upon heating will precipitate on cold or damp walls. If you
have a newly cemented chimney or have had any other
reconstructions / renovations done, you are advised to
wait at least 6 weeks before lighting your fire, to allow the
walls, floor and ceiling to dry out completely.

Lighting the heater for the first time

There can be an unpleasant smell when you light the
heater for the first time. This is caused by the varnish
evaporating and will disappear after a few hours. We
therefore advise you, on initial use, to heat the appliance
at
the highest setting while ventilating the room it is installed
in well.

Extra protection

This heater meets the normal safety standards regarding
surface temperatures, but physical contact with heated
surfaces should be avoided where possible. An additional
guard is recommended to protect young children and
elderly, infirmed or handicapped people.

Disposal

When replacing or otherwise removing the appliance,
it should be disposed of in compliance with current
regulations.
Shut off the connecting tap with coupling before
commencing disassembly. Undo the coupling between the
connecting tap and the appliance. The whole appliance can
now be disassembled and removed.

Guarantee

The warranty for your DRU appliance will be provided by
your supplier. In case of malfunctions, you should always
contact him. You supplier will contact DRU if he feels this
is necessary. The factory warranty for your appliance is
valid for 2 years after date of purchase.
CONVERSION INSTRUCTIONS
CONVERSION INSTRUCTIONS
The conversion must be carried out by a qualified fitter.
Before commencing the conversion:
1. Disconnect the gas supply.

Removing the burner unit

To be able to replace essential components, the entire
burner unit must be taken out of the heater. To do this:
- Open the front and the glass pane.
- Remove the vermiculite tray.
- Disconnect the gas supply.
- Take the burner unit out of the appliance.
A

Replacing the components

Pilot-light jet
Unscrew the nut (1) at the end of the pilot-light hose, pull
the hose with ring clamp our of the pilot-light burner and
remove the jet. Fit the new jet and tighten the nut on the
pilot-light hose firmly.
Main burner jet and airflow regulator
The main burner jet is located under the airflow regulator.
Remove the self-tapping screw on the left to take out the
burner tray. Remove the jet (3) with a spanner and fit the
new one. Replace the burner tray
and replace the airflow regulator.
For G30 (butane) don't (re)place the airflow
regulator.
23
B
Alto/Basso