Advanced Mode For A Single External Switch - JDSU OTU-8000 Manuel De L'utilisateur

Advanced mode for a single
External Switch
OSX distributor
Fig. 51 Scan results with one OSX8000 set as distributor
12 Click on the Switch tab to apply the configuration (see
the optical switch" on page
This command allows to connect one single OSX-8000 and the internal
switch in two different ways:
1 Select the parameter Advanced mode for a single External
switch.
Fig. 52 Advanced mode for Single External Switch
2 Select one of the following configurations:
User Manual 7OTU80050/01
Chapter 3 Installation of the OTU-8000
Configuring the OTU-8000
43).
The Multipexed mode is to be
used when it is planned to add
other OSX-8000 in the future.
This mode allows to add more
OSX-8000 without modifying the
optical cabling of the first one.
The other ports «n-1» of the inter-
nal switch are consequently
unused.
In Extended mode, the last port
of the internal switch is linked to
the OSX. Only one OSX is then
usable for this configuration, the
other ports of the internal switch
can be used only to connect fibers
to be tested ( the number of
usable ports is then of 59: 23
ports on the internal switch + 36
on the OSX)
This mode can be selected if no
other OSX-8000 is planned to be
added in the future.
"Configuring
41