Configuration With More Than One Osx8000 - JDSU OTU-8000 Manuel De L'utilisateur

Chapter 3 Installation of the OTU-8000
OSX8000 additional optical switch
Configuration with more than
one OSX8000
30
OSX8000
C
Optical switch module
Ports
1...36
1 36
Fig. 32 Configuration > 1x36 (up to 30 x 36)
NOTE
The last OSX8000 is not always connected to the «n» of the internal
optical switch (example: 3 OSX8000 connected to an internal switch
1 x 4)
1 Connect C1 from the 2nd OSX8000 to port 1 of the 1st OSX8000.
2 Connect C1 from the last OSX8000 to port n of the 1st OSX8000.
3 Connect the OTU8000 to the first OSX8000, the first OSX8000 to
the second one, the second one to the third one etc., using
command cables
4 Connect all fibers to be tested from the ODF to OSX8000 ports.
OSX8000
C
Optical switch module
Ports
1...36
1 36
OTU-8000
Fig. 33 Configuration
User Manual 7OTU80050/01
Optical switch module
Up to
30...
1...36
1
C1
Optical Switch
Optical switch
module
1
Up to
Optical switch module
30...
Ports
1...36
1
C1
OSX8000
C
Optical switch module
Ports
1...36
1 C1
36
OTDR
OSX8000
C
Ports
C1
36
C
n
C1
OSX8000
C
C1
36