Summary Of The Delivery And The Prerequisites For An Otu-8000 - JDSU OTU-8000 Manuel De L'utilisateur

OTDR plug-in set into
the OTU-8000
(configuration with
one OTDR).

Summary of the delivery and the prerequisites for an OTU-8000

Reference Elements
• OTU-8000 Base
• 19'' brackets mounted
• OTU-8000 Getting Started Manual
• Plexi cover
• Fixation kit for cover
• Fixation kit for rack
EOTU8000E
• Supply connector
• 2 ferrites
• Male Ground connector
• Brackets 21'' or 23''
E98Rackxx
• Screws for fixation on rack
• Modem mounted into the OTU-8000 base
E98EGSM
• GSM Antenna
• Relays mounted into the OTU-8000 base
E98relay
• Supply with a cord ended by a connector
E98ACDC
• AC to DC converter, ended by a female
connector
• Switch module mounted into the OTU-8000
base
E98Xnn
• Angled jumper with the correct connector
• External 36 ports Optical Switch with
brackets 19'' mounted (1U)
EOSX8000
• Jumper OTU-8000 <-> OSX8000 (L = 1m)
• Screws kit
Fig. 15 OTDR Module mounted + User Manual
User Manual 7OTU80050/01
Chapter 1 Prerequisites and delivery of the OTU-8000
Summary of the delivery and the prerequisites for an OTU-8000
OTDR Manual
Prerequisite
– Rack 19''
– POZI Screwdriver N°2 (to set the
brackets into the rack)
– Electric wires: section < 1,5mm².
– -48V DC to feed the OTU-8000
– IP Network with: IP address /
Subnet Mask / Gateway
– For plexi fixation: Wrench 7
(Metric) or Wrench HS8 1/4'' (Inch)
– RJ45 cable
– E-mail Server with SMTP address
– PC with the Web Browser (Internet
Explorer 6.0 or equivalent)
– Female ground connector
– Rack 21'' or 23''
– POZI Screwdriver N°2 & thread
lock
– SIM DATA card without PIN code
– POZI Screwdriver N°1 (to remove
the upper cover of the OTU-8000)
– 100 - 240 AC Voltage, to feed the
OTU-8000
– Rack height (+ 1U with 1
OSX8000)
11