Installation For The Gsm Option - JDSU OTU-8000 Manuel De L'utilisateur

Chapter 3 Installation of the OTU-8000

Installation for the GSM Option

Installation for the GSM Option
26
NOTE
The SIM card must be set into the OTU-8000 when the GSM option
is available.
Before installing the OTU-8000, and all the other options, you must
install the SIM Data card into the slot provided for that purpose in the
OTU-8000, if you acquired the GSM option.
1 Remove the PIN code from this SIM Data Card, before installing it
into the OTU-8000:
– Set the card into a portable phone and use the corresponding
menu to remove the PIN code.
2 Unscrew the 2 screws on each side of the GSM block, on the front
panel.
Fig. 25 GSM option on front panel
3 Pull carefully the GSM block to remove it from its housing.
4 Insert the SIM card in the right way, as shown on the PCB.
Fig. 26 Insert SIM Card
5 Put back the GSM front cover by fastening the 2 screws removed in
step 2.
6 Plug the GSM antenna to the GSM connector onto the OTU-8000.
User Manual 7OTU80050/01
Unscrew