Publicité
Les langues disponibles
Les langues disponibles
Chapter 3 Installation of the OTU-8000
Configuring the OTU-8000
40
1 OSX8000 as distributor
Address 2
Address 1
Address 31
Fig. 50
Connection OTU-8000 <-> OSX8000 <-> OSX8000
2 Connect all the others OSX8000 (see
3 Press Settings button onto the OSX8000 multiplexer front panel.
The LED Addr. turns on, in solid green.
4 Enter the address 31 for the OSX8000 multiplexer.
5 Click on A
onto the OSX Setup page of the Web Interface.
PPLY
6 Confirm the address modification in the new dialog box pressing
OK.
7 Once completed, and if the addres has been successfully modified:
– a green text confirm the address modification.
– the LED Addr. onto the OSX8000 turns solid green
8 Press the Settings button again to complete the address modifica-
tion for OSX8000 multiplexer.
9 Follow step
2
to
4
from
the configuration of the following OSX8000.
The first OSX8000 set after the multiplexer will always have
address 1.
The addresses must be consecutive! (1, 2, 3, 4...).
10 Once all the OSX8000 are configured, you must launch a scan to
detect all the connected OSXs, clicking on the button F
11 Once scan is completed, the External Switches detection dialog box
is displayed with, for each OSX8000 address, its serial number and
C/P data.
– the OSX8000 Address 31, which represent the OSX8000 multi-
plexer, its serial number and C/P data
– the OSX8000 with addresses 1,2, 3 etc., which represent all the
OSX8000 connected to this multiplexer one, their serial numbers
and C/P data.
User Manual
7OTU80050/01
Figure 46 on page
"OSX8000 in cascade mode" on page 37
Command cable OSX <-> OSX
(Kit E98OSXXOSX)
Command cable OTU <-> OSX
(Kit E98OTUXOSX)
38).
for
S
.
ULL
CAN
Publicité
Chapitres
