Machine Description - Scheppach HM100T Traduction Des Instructions D'origine

GB
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Strasse 69
D-89335 Ichenhausen
Dear Customer,
We hope you enjoy working with your new machine
and we wish you every success.
Note:
According to the applicable Product Liability Law, the
manufacturer of this device is not liable for injury to
persons or damage caused to or by this device in the
event of:
improper handling,
•
non-compliance with the operating instructions,
•
repairs by third parties who are not authorised spe-
•
cialists,
installation and replacement of non-original spare
•
parts,
use other than for the intended purpose,
•
failure of the electrical equipment in the event of
•
non-compliance with electrical instructions and
VDE Specifications 0100, DIN 57113 / VDE 0113.
Please note:
Before assembling and commissioning the device,
read the entire user manual.
This user manual is designed to make it easier for
you to get to know your machine and to use it for its
intended purpose.
The user manual contains important information
about how you can work with the machine in a safe,
professional and economic way, how you can prevent
hazards, save money on repairs, reduce downtimes
and increase the reliability and durability of the ma-
chine.
In addition to the safety instructions in this user man-
ual, you must also, without fail, observe the regula-
tions relevant to your country for the operation of this
machine.
Store the user manual in a plastic cover close to the
machine, protected from dirt and moisture. It must
be read and followed carefully by every user before
working with the machine. Only those who have been
instructed in the machine's use and taught about as-
sociated hazards, may use it. The minimum age re-
quirement must be complied with.
In addition to the safety notices contained in this op-
erating manual and the particular instructions for your
country, the generally recognised technical regula-
tions for the operation of identical devices must be
complied with.
24 І 204
internet: www.scheppach.com / email: service@scheppach.com / telefon: +(49)-08223-4002-99 / telefax: +(49)-08223-4002-58

2. Machine description

Rip fence
1.
Unlocking button
2.
On/off switch for table operation
3.
4. Upper saw table
Handle
5.
Saw-shaft lock
6.
Motor
7.
Extension fence
8.
Lower saw table
9.
10.
Dial
11. Lower saw table
Saw blade
12.
Locking button
13.
Lower saw blade cover
14.
Work piece holder
15.
Mitre lock
16.
17. Saw blade guard, moveable
18. Lock screw
Wood chip collection bag
19.
Lock pin
20.
Set screw
21.
On/off switch for chopping operation
22.
Cross stop
23.
24. Star knob screws
Star knob screw
25.
Indicator
26.
27.
Dial
Push stick
28.
Allen key 6 mm
29.
Allen key 3 mm
30.
31.
Foot
Allen screw
32.
Rubber foot
33.
34.
Nut
Screw
35.
36.
Fixing nut
37. Upper saw blade guard
38. Riving knife
Extension fence
39.
Allen screw
40.
Lock nut
41.
Angle indicator
42.
Indicator
43.
44. Allen screw
Lock nut
45.
Dust extraction nozzle
46.
Screws (saw blade guard)
47.
Screws (upper saw table)
48.
Screws (lower saw table)
49.
50. Flange screw
51. Outside flange
Inside flange
52.
Moveable stop rail
53.