Pinlock ® Visor - SCHUBERTH C3 PRO Mode D'emploi

C. THE HELMET
Caution :
Never ride without making sure that the chinstrap is correctly
fastened and adjusted and properly positioned. If the
chinstrap is not correctly adjusted or fastened, the helmet
could be displaced in the event of an accident.
Caution :
Closing the comfort pad of the chinstrap alone will not
provide adequate protection. The chinstrap must always be
fully fastened.
Caution :
Never open the chinstrap while riding.
®
11. PINloCk VISor
® lense is affi xed to the inside of the face shield with
The Pinlock
a fl exible silicone seal and held in place under tension by the two
eccentric pins. This creates an insulating air cushion between the
®
face shield and Pinlock lense preventing any fogging of the face
shiled.
66
COATING
The main plate has a HighClear ®
sides.
Note:
The helmet should never be used to hold gloves or any other
objects as this may damage the scratch-sensitive Pinlock
lense.
Note:
The Pinlock ® lense is supplied with a protective fi lm. Remove
this fi lm before using the helmet for the fi rst time.
Note:
The Pinlock ® lense may only be used in conjunction with the
SCHUBERTH main face shield that has been specially designed
for this purpose. Other face shields must not be fi tted.
Opening the face shield
To open the face shield, use your thumb to
push the face shield up using one of the fi nger
tabs situated to the left and right of the face
shield, and move it to the desired position.
Face shield (including urban position)
The face shield can be locked in any one of seven positions.
The second position (urban position) locks in place more fi rmly,
providing greater resistance when the face shield is in this
position. This makes it easier to lock the face shield in the urban
position, especially while riding.
anti-scratch coating on both
®
67