Putting On The Helmet And Taking It Off; Putting On The Helmet - SCHUBERTH C3 PRO Mode D'emploi

C. THE HELMET
Reflective panels
Together with the silver reflective strips located laterally at the
back of the neck collar, the two reflective panels integrated
into the left and right areas under the face shield help make
the motorcycle rider more noticeable on the road, especially
in conditions of poor visibility. If the helmet is plain (no
decoration), the SCHUBERTH name also appears on the front and
back of the helmet in a reflective film.
Note:
Keep the reflective safety areas clean.
Note:
When riding in France, local law requires that further
reflective safety stickers be attached to the front, back and
both sides of the helmet.
88
D. PUTTING THE HELMET ON AND TAKING
IT OFF

1. PUTTING oN THE HElMET

Note:
See section C.10. for operation of the chin-strap / fastener
system.
1. Open and lock the chin bar. Make sure the sun visor
is retracted into the helmet shell.
2. Open the chinstrap and chinstrap comfort pad.
3. Pull apart the lower ends of the chinstrap.
4. It will now be easy to put the helmet on.
5. Close the chinstrap comfort pad (with the Velcro fastener)
6. Fasten the chinstrap by pushing the ratchet tongue into the
lock so that you hear it engage properly.
7. Make sure the chinstrap passes under the chin and fits
snugly.
8. Swing the chin bar down until you hear both locks close.
9. Check that the chin section is securely locked by pressing it
up from below.
Note:
Regularly check that the chinstrap fits correctly and is
adjusted to the correct length (see section C.10.).
Caution:
Never ride with the chin bar raised!
89