Maintenance; Regular Cleaning Of The Anti-Static Bar; Cleaning Of A Heavily Contaminated Anti-Static Bar - Simco ION Performax Easy Ex Mode D'emploi

8 Maintenance

Warning:
- Disconnect the power supply before carrying out work on the unit.
- The emitters are sharp and can cause injury.

8.1 Regular cleaning of the anti-static bar

Cleaning the ionization bar is the only maintenance that needs to be done. The frequency of
cleaning depends on the amount of pollution in the environment and thus very application
dependent. As a basis you could start with once a month.
- Clean the emitters, the entire surface of the cast resin and the side strips regularly with a
hard, non-metallic brush. Clean also the Aluminum profile when it is contaminated.

8.2 Cleaning of a heavily contaminated anti-static bar

- Dismount the anti-static bar as described in chapter 5.6.
- Remove the anti-static bar from the Ex zone.
- Clean the anti-static bar with a suitable cleaning material (e.g. Isopropylalcohol). By very
heavy contamination Veconova 10 can also be used (www.eco-nova.nl).
Let the anti-static bar dry completely before putting back into use.
- Mount the anti-static bar as described in chapter 5
(if he situation permits, the anti-static bar may also be cleaned at the position where it is
mounted. The anti-static bar must be voltage-free).
PerformaxEasyExPerformaxEasyExSpeed_UM_9752153010_NL_D_ GB_FR_V2_3
FR
69