Preparation; Boiling Water; Heating Water - Beem Samowar 2017 Mode D'emploi

Masquer les pouces Voir aussi pour Samowar 2017:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

29

Preparation

NOTE
Do not operate the device without water. If this does happen, the heating
element of the device switches off automatically (dry-running protection). In this
case, allow the device to cool down for around 5 – 10 minutes before water is
poured in and the device is used again.
If water needs to be added, switch off the device, pull the mains plug out of the
plug socket and allow the device to cool down for a few minutes. When opening the
lid (12), use potholders or similar gloves and be careful.

Boiling Water

1. Pour water into the water reservoir (5) (see the "Operation" chapter | "Filling the Water
Reservoir").
2. Place on and close the lid (12) (see the "Operation" chapter | "Removing / Attaching
the Lid").
3. Turn the control dial (6) to the highest temperature (BOIL) to switch on the device and
start boiling the water. The
it has completely evaporated.

Heating Water

If water is just to be heated, boil the water once (see the "Preparation" chapter | "Boiling
Water"). As soon as it boils, use the control dial (6) to select the setting you want. The
thermostat enables individual, infi nite setting of the water temperature.
Interval Boiling
For an energy-saving way to boil water, it is advisable to choose the interval boiling
setting. Here the thermostat regulates the supply of power as required. The device
switches off the heating element once the water has boiled and switches it back on again
as soon as the temperature of the water drops.
For this purpose, boil the water once (see the "Preparation" chapter | "Boiling Water"). As
soon as it boils, turn the control dial (6) down so that the control lamp (8) goes out.
As soon as the thermostat switches the heating back on, the control lamp lights up again.
Switch off the device after each use by turning the control dial to the OFF position.
Pull the mains plug out of the plug socket and allow the device to cool down before
it is cleaned and / or stored away (see the "Cleaning and Care" chapter).
07123_DE-EN-FR-ES-IT_A5_V1.indb 29
07123_DE-EN-FR-ES-IT_A5_V1.indb 29
control lamp (8) lights up. The water carries on boiling until
EN
18.06.2018 12:28:07
18.06.2018 12:28:07

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

07123

Table des Matières