Beem Samowar 2017 Mode D'emploi page 38

35
Troubleshooting
If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device cannot
be switched on.
The fuse in the fuse
box is triggered.
Water runs out of
the device.
No water or only a
very small amount
of water runs out of
the discharge tap.
A large amount of
steam is produced
in the brewing
process.
07123_DE-EN-FR-ES-IT_A5_V1.indb 35 07123_DE-EN-FR-ES-IT_A5_V1.indb 35
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
No mains voltage is present.
The control dial (6) has not
been activated.
Too many devices connected
to the same circuit.
No error can be identifi ed.
There is too much water in the
water reservoir (5).
The discharge tap (9) is still
open.
The discharge tap is blocked.
The device is furred up.
The device is furred up.
Fix
Insert the mains plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Turn the control dial to the
highest temperature (BOIL).
Reduce the number of devices
in the circuit.
Contact our customer service
department.
Do not overfi ll the water
reservoir!
Close the discharge tap and
ensure that the lever (10)
cannot be blocked.
Clean the discharge tap.
Descale the device (see the
"Cleaning and Care" chapter |
"Descaling").
Descale the device (see the
"Cleaning and Care" chapter |
"Descaling").
18.06.2018 12:28:08 18.06.2018 12:28:08
EN