Before Initial Use - Beem Samowar 2017 Mode D'emploi

27

Before Initial Use

NOTES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is
resistant to splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below
the adjustable feet.
• There may still be some production residues on the device. To avoid harmful
effects to your health, clean the device thoroughly before you fi rst use it (see
the "Cleaning and Care" chapter).
1. Fully unwind the mains cable from the cable winder.
2. Set up the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
3. Ensure that the control dial (6) is in the OFF position. Insert the mains plug into a prop-
erly installed plug socket that is easily accessible.
4. Before you fi rst enjoy tea or hot instant beverages, we recommend that you carry out
a trial run to remove any possible production residues. To do this, follow the instruc-
tions in the "Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a
small amount of smoke and / or an odour to be produced. This is normal and not a
device defect.
5. Perform this process twice. Caution! Do not drink this water!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
Operation
Control Dial
The control dial (6) is used to switch the device on and off and set the temperature of the
water. The following settings can be selected with the control dial:
OFF The device is switched off.
WARM Warm water
07123_DE-EN-FR-ES-IT_A5_V1.indb 27 07123_DE-EN-FR-ES-IT_A5_V1.indb 27
EN
18.06.2018 12:28:06 18.06.2018 12:28:06