Before Initial Use - Beem Samowar Mr. Tea V2 Mode D'emploi

27
Not shown:
• MAX marking (in the water reservoir)
• Limescale fi lter (in the water reservoir)
• Operating instructions

Before Initial Use

NOTES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is
resistant to splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below
the adjustable feet.
• There may still be some production residues on the device. To avoid harmful
effects to your health, clean the device thoroughly before you fi rst use it (see
the "Cleaning and Care" chapter).
1. Fully unwind the mains cable from the cable winder.
2. Set up the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
3. Ensure that the On / Off switch (8) on the side of the water reservoir (7) is in the 0 (Off)
position. The operating lamp must not be lit.
4. Insert the mains plug into a properly installed socket that is easily accessible.
5. Before you fi rst enjoy tea or hot instant beverages, we recommend that you carry out
a trial run to remove any possible production residues. To do this, follow the instruc-
tions in the "Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a
small amount of smoke and / or an odour to be produced. This is normal and not a
device defect.
6. Perform this process twice if necessary. Caution! Do not drink this water!
7. Clean the device and accessories (see the "Cleaning and Care" chapter).
05407_DE-EN-FR-NL_A5_V1.indb 27 05407_DE-EN-FR-NL_A5_V1.indb 27
EN
27.11.2017 16:54:14 27.11.2017 16:54:14