Before Initial Use; Set-Up And Connection - Beem Samowar 2030 Mode D'emploi

23

Before Initial Use

1. Remove any fi lms and stickers which are used for advertising or protection during transpor-
tation. Never remove the rating plate and any possible warnings.
2. Wipe the device with a clean, damp cloth. Clean the permanent fi lter (2) and the coffee
jugs with mild detergent and warm water.
3. Set up the device (see the "Set-Up and Connection" chapter).
4. Before you fi rst enjoy tea or hot instant beverages, we recommend that you carry out a
trial run to remove any possible production residues. To do this, follow the instructions in
the "Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device
defect.
5. Repeat this process twice. Do not drink this water!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).

Set-Up and Connection

PLEASE NOTE
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below the
adjustable feet.
•
Place the device in a suitable location, following the safety notices and the notices provided
at the beginning of this chapter.
• Fully unwind the connection, connect it to the appliance connection (10) and insert the
mains plug into a properly installed socket that is easily accessible.
06119_DE-EN-FR-ES-IT_A5_V2.indb 23 06119_DE-EN-FR-ES-IT_A5_V2.indb 23
EN
28.03.2019 12:43:25 28.03.2019 12:43:25