Preparation; Boiling Water; Heating Water - Beem Samowar 2030 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

25

Preparation

PLEASE NOTE
Do not operate the device without water. If this does happen, the heating element
of the device switches off automatically (protection against running dry). In this case,
allow the device to cool down for around 5 – 10 minutes before water is poured in
and the device is used again.
If water needs to be added, switch off the device, pull the mains plug out of the plug
socket and allow the device to cool down for a few minutes. When opening the lid (4),
use potholders or similar gloves and be careful.

Boiling Water

1. Pour water into the water reservoir (6) (see the "Operation" chapter | "Filling the Water
Reservoir").
2. Turn the thermostat control (7) clockwise to switch on the device and start boiling the
water. The heating control lamp (9) lights up. The water carries on boiling until it has
completely evaporated.

Heating Water

If water is just to be heated, boil the water once (see the "Boiling Water" section). As soon as it
boils, turn the thermostat control (7) anticlockwise until it resists. The heating control lamp (9)
goes out and the device switches off. The water gradually cools if it is not removed and reused.
Interval Boiling
For an energy-saving way to boil water, it is advisable to choose the interval boiling setting.
Here the thermostat regulates the supply of power as required. The device switches off
the heating element once the water has boiled and switches it back on again as soon as the
temperature of the water drops.
For this purpose, boil the water once (see the "Boiling Water" section). As soon as it boils, turn
the thermostat control (7) down so that the heating control lamp (9) goes out.
As soon as the thermostat switches the heating element back on, the heating control lamp
lights up again.
Switch the device off after every use by turning the thermostat control anticlockwise until
it resists.
Pull the mains plug out of the plug socket and allow the device to cool down before it is
cleaned and / or stored away (see the "Cleaning and Care" chapter).
06119_DE-EN-FR-ES-IT_A5_V2.indb 25
06119_DE-EN-FR-ES-IT_A5_V2.indb 25
EN
28.03.2019 12:43:25
28.03.2019 12:43:25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

06119

Table des Matières