Before First Using This Appliance; How To Use This Appliance; Boiling Water - Beem Mr. Tea S 2.4.0 Mode D'emploi

5. Before first using this appliance

• Ensure that all packaging material has been removed from the appliance (protective
film, etc.).
• Under no circumstances remove the rating label or any warning labels.
CAUTION: check that the appliance is not damaged. If any parts are damaged,
do not use the appliance and contact a qualified service engineer.
• Place the appliance on a level, stable and heat-resistant surface.
• Do not place the appliance near a source of heat or steam, or in the vicinity of
combustible material.

6. How to use this appliance

6.1.

Boiling water

• Remove the water container from the base unit to fill it with water.
• Pour the required amount of fresh water (note the maximum capacity of 4.0 litres);
do not fill the water container past the fill level mark (9).
• Replace the steam element lid and the teapot (5+7).
• Place the water container onto the base unit (17). It can be placed in any position
(360° rotation).
• Ensure that the adjusting knob (16) is turned anticlockwise until it reaches its detent.
• Then insert the plug into the mains socket.
• Turn the adjusting knob clockwise to its detent. The thermostat allows stepless
adjustment of the degree of heat. You can choose between the settings: boil /
interval boil / hot / warm.
• If you turn the adjusting knob to the detent, the water will boil rapidly. If you leave
the adjusting knob in this position, the water will boil continuously until it eventually
all evaporates. In order to avoid this continuous boiling function, push the knob back
down until the signal light on the base unit goes out. Now the thermostat only
switches on again when the temperature of the water drops, heating it again. In this
way, the thermostat regulates energy supply in accordance with requirements, saving
a great deal of energy. The signal light switches on and off in the thermostat cycle.
• Guideline values:
●●● - Boiling water:
- Interval boiling:
●● - Hot water:
● - Warm water:
• When the water container is taken from the base unit it is disconnected from the
electricity supply. The thermostat switches on again when it is placed back on the
base unit.
BEEM – Elements of Lifestyle
Adjusting knob turned to the detent; water
temperature approx.
Maximum 1/4 turn back - as soon as the water has
boiled; water temperature approx.
Adjusting knob turned back by about 1/3
(to the position marked "●●"); water temperature
approx.
85°C – 95°C
Adjusting knob turned back by about 2/3
(to the position marked "●"); water temperature
approx.
60°C – 70°C
100°C
95°C – 100°C
18 / 88 18