Thermostat Control; Filling The Water Reservoir - Beem Samowar Mr. Tea V2 Mode D'emploi

EN
Operation
To allow the device to be supplied with power and be used, move the On / Off switch (8)
on the side of the water reservoir (7) to the I (On) position. The operating lamp in the On /
Off switch lights up.

Thermostat Control

The thermostat control (9) is used to switch the device on and off and set the temperature
of the water.
Switch on Turn the thermostat control clockwise until it resists.
Switch off Turn the thermostat control anticlockwise until it resists.
The control lamp (11) lights up as soon as the heating element of the device starts heating
the water. The control lamp lights up at intervals when the water is being kept warm and
when boiling at intervals.
Removing / Attaching the Lid
1. Hold the lid (4) at the opening and pull it upwards.
If the device has been in operation, use potholders or similar gloves as the lid might
be hot. Always allow the device to cool down before using it again.
2. To close the lid, place it on straight and press it down fi rmly with a little force. It must
click audibly into place and sit fl at.
3. Place the teapot (3) on the lid. This closes off the device at the top.

Filling the Water Reservoir

Only ever fi ll the water reservoir (7) with fresh, clear tap water. Do not pour in any
other liquids.
1. Remove the water reservoir from the base station (10).
2. Take off the lid (4) (see the "Removing / Attaching the Lid" section).
3. Pour the desired quantity of water (maximum 4 litres) into the water reservoir. Note the
MAX marking.
4. Close the lid (see the "Removing / Attaching the Lid" section).
05407_DE-EN-FR-NL_A5_V1.indb 28 05407_DE-EN-FR-NL_A5_V1.indb 28
28
27.11.2017 16:54:14 27.11.2017 16:54:14