Bartscher 900 MASTER Serie Mode D'emploi page 36

pilot burner, the thermocouple and finally, the pipe union of the ramp. Then unscrew the two screws
that fix the supporting plate: the latter must be re-used to fix the new valve. Then substitute the part.
Thermocouple
To substitute the thermocouple of the fryer, the knobs and the control panel must be removed, then
open the compartment door. It is then necessary to unscrew the connector of the thermocouple on
the tap and the one on the pilot unit, then substitute the part.
Heating elements (figg. 18, 19, 20 - pag. 6)
To substitute the heating elements open the compartment door, then remove the heating element
protection (1) unscrewing the fixing screws (2) slightly. Then unscrew the connectors that fix the
thermostat extensions (3), remove the clips (4) that fix the thermostat to the heating element and
dismantle the bulb support (5); then remove everything. Then unscrew the screws (6) that fix on the
handle (7) for the rotation of the heating element then remove it from inside the vat after
disconnecting it.
WHEN SUBSTITUTING, ONLY ORIGINAL SPARE PARTS SUPPLIED BY THE
MANUFACTURER MUST BE USED. THE OPERATION MUST BE CARRIED OUT BY
AUTHORIZED PERSONNEL.
ATTENTION! If the substitution operation has involved gas system components the
tightness of the gas system and correct functioning of the various components must be
checked.
Pag. 35