Bartscher 900 MASTER Serie Mode D'emploi page 34

If a basket is put into the vat with only partly drained food, it can cause a sudden boiling of the oil
and the subsequent formation of foam due to oil emulsion with the water content of the food. Lift
out the basket and then put it back so that the foam will condense.
Periodic oil filtration (Fig. 17 - pag. 5)
During cooking different sized particles come off the food and the largest end up on the bottom
grid (3), while others are deposited in the cold area at the bottom of the vat. To prevent these
residues from ruining the oil and consequently the food, they must be eliminated periodically. After
leaving the oil to cool the bottom grid should be removed by lifting it out slowly so that no large
residues will be dispersed in the oil. Having done this the drain tap must be opened (4) making sure
that the basket (5) in the basin (6) is positioned below the drainpipe, and all the oil should be
drained. If at the end of this operation the oil is not adequately purified, it must be filtered again.
Then the vat must be cleaned, the drain tap closed and it can be filled with oil.
ATTENTION! Only use the appliance under surveillance. Never use the fryer when it is
empty. Make sure the burners have been switched off before draining the oil.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, check that the energy
supply and the control knobs are set correctly; if all is regular, call customer service.
If the anomaly concerns an electronically controlled fryer below is a table indicating the steps to
take.
ALARM SIGNAL
EO flashing and buzzing
E2 flashing and buzzing
EOC flashing and buzzing
PF alternating temperature value
with buzzing
AL1 alternating temperature value
with buzzing
MEANING
Incorrect probe
Probe defect
Temperature above limit
Configuration fault
Circuit fault
Long period power failure
The temperature is too low
Pag. 33
ACTION
Call the technician
Try turning off and then on
Call the technician
Call the technician
Press the START/STOP button
Call the technician