Switching On; Switching Off - Nuova Simonelli Microbar Mode D'emploi

4.4

SWITCHING ON

NOTE: in case the following procedure shouldn't
take effect, see the chapter on "Problems
and Solutions".
After the preliminary operations:
1 Press the machine's main switch and turn it to
"ON"..
The LCD will then light up and read as follows:
To switch the machine on definitively, press the
"ENTER" key:
the machine automatically loads the heater with
water and begins heating operations. When the
desired temperature is reached the display will
show the following message:
50
ON ON
Fig. 21
NOTE: the starting time is about 3 minutes.
NOTE: The appliance is endowed with a security
system that will stop the machine after about
1.5 minutes of constant functioning of the
pump (to avoid pump overheating). In this
case, switch off the main switch of the machi-
ne and then turn it on again.
The machine is now ready to be used.
WHEN INSTALLING THE MACHINE FOR THE
FIRST TIME OR AFTER WATER HEATER UNIT
MAINTENANCE, PRESS THE BUTTON TO
DISPENSE HOT WATER BEFORE DISPENSING
ANY COFFEE.
REPEAT THIS OPERATION AS REQUIRED AND
UNTIL THERE IS AN EVEN FLOW OF WATER
FROM THE NOZZLE.
4.5

SWITCHING OFF

To switch off the machine, proceed as follows:
• Hold the "ENTER" key down for 5 seconds with
the machine switched on:
• The LCD will read as follows:
• To switch the machine off fully, press the main
switch and turn it to the "OFF" position.
WARNING
OFF OFF
Fig. 22
EN