Manual Functions - Ecolab MULTRONIC Notice Technique

The measured value that is not included anymore in the comparison is no longer displayed in
the measurement mask. The active module may possibly change, and will be marked with the
star (*) again.
The control is turned of with the appearance of the alarm message. This message can be
acknowledged with ENTER. The measuring mask is displayed with the information
Controller: Off.
The control function can only be used again when the corresponding probe has been replaced
or newly calibrated.
9.4

Manual functions

CAUTION
Select manual functions from the main menu to check the Multronic outputs and the
downstream devices.
Main menu:
The following screen appears:
In order to activate relay outputs place the cursor over the corresponding point for the relay,
starting on the left with relay 1. Click ENTER to switch the output on and off. A relay number is
displayed which identifies the switched state. The output will remain active until it is switched
off by clicking ENTER or by placing the cursor over the menu option relay output.
Select the corresponding current output number in the line current output to check the current
outputs. Click ENTER to switch on the maximum output current for this current ouptut. The
output current will remain active for as long as the ENTER key is depressed. The minimum
current for this current output can also be selected and output in this screen. The current
status of the active current output value is displayed.
417101163_Multronic.doc
Before switching on an output ensure that no risks can arise to other persons when activating
pumps, valves, etc.
It is not possible to determine which probe
measures wrongly if two measured values
are compared and the measured values
deviate too much from one another. The
following alarm message is therefore issued.
- 75 - Rev: 5.07-08