Ecolab MULTRONIC Notice Technique page 60

7.1.4.1.2 Configuration System page 2
The limit alarm delay specifies the time (adjustable) at which an alarm message is issued after
a limit condition has been reached.
Value range: 0 sec to 600 sec
The limit alarm repetition function is used to specify the time at which an acknowledged limit
alarm message is issued again without leaving the limit condition area.
Value range: 0 min to 240 min, with off-option (no alarm repetition)
The control variable display can be used to enable the control variable of the selected PID
controllers to be displayed in % instead of the relay line in the measurement mask.
Value range: Off / On
The control variable indication is only active for PID controllers. The setting is not saved
permanently (The relay status line becomes active again after system rest or restart). The
displayed percentage can be used to adjust the PID parameters more accurately.
The internal clock can be set through the date/time option. The format of the date is
month/day/year in two digits. After confirmation the date/time it lasts about 2 sec. to take over
the setting. After take over of the date/time the input-cursor will be positioned on the date/time
selection.
Value ranges:
Date: 01/01/00 to 12/31/99
Time: 00:00 to 23:59
NOTE
Config.-menu opens the configuration menu.
The page 1 function opens the first page of the system configuration menu.
7.1.4.2 Configuration Modul
(For a more detailed description, see section 4.1 – Measurement Parameters – in the
operating manual of the relevant measurement module.)
417101163_Multronic.doc
There is no automatic change between summer and winter time. The change must be
carried out manually.
The idle time function is used to specify the
time that may pass between operating two
keys before the measurement screen is
automatically opened again.
Value range: 1 min to 60 min
Select Modul Configuration through placing
the cursor onto the selected item "modul" and
operating the ENTER key.
- 59 - Rev: 5.07-08