Manual Functions - Ecolab MULTRONIC Notice Technique

7.1.5

Manual functions

- Relay output test functions
- Current output test functions
CAUTION
The following manual functions can be selected from the main menu to inspect the outputs of
the Multronic and downstream units.
Main menu:
The following screen appears:
To activate relay outputs place the cursor on the corresponding point of therelay number in the
relay output line; start left with relay 1. The outputcan be activated or deactivated by pressing
the ENTER key. The activatedstate is indicated by the display of the relay number. The output
remainsactivated until it is deactivated via the ENTER key or until the cursor isplaced on the
relay output selection.
To inspect the current outputs, the corresponding current output number in the current output
line must be selected. The maximum output current of this current output is switched through
operating the ENTER key. It remains activated for as long as the ENTER key is operated. The
minimum current of this current output can also be selected on this screen. The current status
of the active current output value is displayed.
Current output:
The return function selection option is used to open the manual function selection screen.
417101163_Multronic.doc
Before activating an output it must be ensured that no danger is posed to other persons
through activation of pumps, valves, etc.
- 60 - Rev: 5.07-08