Disposal - Beurer BC 54 Mode D'emploi

Error Possible
message cause
The cuff was
not attached
correctly.
An error oc-
curred during
measurement.
4
The inflation
pressure is
higher than
4
300 mmHg or
the measured
blood pressure
is outside the
measuring
range.
The batteries
are almost
empty.
4
Solution
Please observe the notes
in chapter "7. Usage"
under the section "Atta-
ching the cuff".
During a new measure-
ment, check whether the
cuff can now be inflated
properly.
Please wait one minute
and repeat the measu-
rement.
Ensure that you do not
speak or move during
the measurement.
Insert new batteries into
the device.
Error Possible
message cause
The data could
not be sent via
Bluetooth
7
A device error
has occurred.
8
If the problems persist despite the proposed corrective
actions, please contact customer service.

10. Disposal

Repairing and disposing of the device
• Do not repair or adjust the device yourself. Proper op-
eration can no longer be guaranteed in this case.
• Do not open the device. Failure to comply will result in
voiding of the warranty.
• Repairs must only be carried out by Customer Services
or authorised suppliers. Before making a claim, please
check the batteries first and replace them if necessary.
40
Solution
Proceed as described in
chapter „7. Usage" under
. the section
®
„Transfer via
Blue-
" into the manual
tooth ®
memory mode and try to
restart the data transfer.
Please repeat the mea-
surement after a pause
of one minute.