What If There Are Problems; Disposal - Beurer BM 26 Mode D'emploi

10. What if there are problems?

Problem Possible cause
The cuff could not
be correctly inflated.
An error occurred
during the
measurement.
The inflation
pressure is higher
than 300 mmHg
or is outside of the
measurement range.
The batteries are
almost empty.
Solution
Please take another meas-
urement to check whether
the cuff can be correctly
inflated.
Make sure that the cuff
connector is correctly con-
nected to the device and
that the line is not bent;
also make sure that neither
your arm nor other heavy
objects are pressing on
the line.
Please wait one minute and
repeat the measurement.
Ensure that you do not
speak or move during the
measurement.
Insert new batteries into the
device.

11. Disposal

Repairing and disposing of the device
• Do not repair or adjust the device yourself. Proper operation
can no longer be guaranteed in this case.
• Do not open the device. Failure to comply will invalidate the
warranty.
• Repairs must only be carried out by Customer Services or
authorised retailers. Before making a claim, please check the
batteries first and replace them if necessary.
• For environmental reasons, do not dispose of the
device in household waste at the end of its service life.
Dispose of the device at a suitable local collection or
recycling point in your country. Dispose of the device in
accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment). If you have any questions, please
contact the local authorities responsible for waste disposal.
Disposing of the batteries
• Empty, completely flat batteries must be disposed of through
specially designated collection boxes, recycling points or
electronics retailers. You are legally required to dispose of
the batteries.
• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
24