Cleaning And Maintenance; What If There Are Problems - Beurer BC 54 Mode D'emploi

8. Cleaning and maintenance

• Clean the device and cuff carefully using a slightly
damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy
objects on the device and cuff. Remove the batteries.

9. What if there are problems?

Error Possible
message cause
Unable to re-
cord a pulse.
You have mo-
ved or spoken
during the
measurement.
Solution
Please wait one minute
and repeat the measu-
rement.
Ensure that you do not
speak or move during
the measurement.
Error Possible
message cause
The cuff was
not attached
correctly.
An error oc-
curred during
measurement.
The inflation
pressure is
higher than
300 mmHg or
the measured
blood pressure
is outside the
measuring
range.
The batteries
are almost
empty.
39
Solution
Please observe the notes
in chapter "7. Usage"
under the section "Atta-
ching the cuff".
During a new measure-
ment, check whether the
cuff can now be inflated
properly.
Please wait one minute
and repeat the measu-
rement.
Ensure that you do not
speak or move during
the measurement.
Insert new batteries into
the device.