Beurer BC 54 Mode D'emploi page 38

phone in which you must enter this six-digit PIN code.
After successfully entering the code, the device will
be connected to your smartphone.
Step 1: BC 54
Activate Bluetooth
chapter „6. Initial use", section
®
"Bluetooth
Step 2: " beurer Health Manager" app
In the " beurer Health Manager" app, add
the BC 54 under "Settings/My devices".
Step 3: BC 54
Take a measurement.
®
on your device (see
").
Step 4: BC 54:
Data transfer immediately
following measurements.
• If ®
Bluetooth
transfer has been ac-
tivated, data is trans-
ferred after
confirmed the
memory and pressing
the START/STOP but-
ton .
The " beurer Health Manager" app must be active to
allow data transfer.
If your smartphone has a protective cover, remove this
to ensure that there is no interference during the transfer.
Begin the data transfer in the " beurer Health Manager"
app.
We would explicitly draw attention to the fact that the
software to hand is not a medical product in accordance
with EU Directive 93/42/EEC.
The values displayed are purely for visualisation purposes
and must not be used as a basis for therapeutic treat-
ments. The software is not part of a diagnostic-medical
system.
38
Step 4: BC 54:
Data transfer at a later
point:
data • Go to memory mode
(chapter „7. Use", sec-
tion „Saving, displaying
having and deleting measured
user values"). Select
desired user memory.
The Bluetooth
starts automatically.
the
®
transfer