Technical Data - Kärcher MC 250 Mode D'emploi

Malfunction
17

Technical data

Device performance data
Travel speed
Travel speed, backwards
Working speed
Working speed (max.)
Climbing ability (max.)
Turning circle
Electrical system / battery
Battery type
Working voltage of the battery
Battery capacity
Dimensions and weights
Length
Width
Height
Net weight (transport weight)
Approved total weight
Maximum permissible front axle load
Maximum permissible rear axle load
Trailer coupling vertical load
Trailer load, inertia-braked
Unbraked trailer load
Cause
Hydraulic oil temperature too low.
Hydraulic oil level is too low.
Fault in the drive.
Engine oil pressure is too high.
Parking brake active.
Low fuel level.
Service required.
Regeneration process required.
Regeneration process has generated
an error (NOx monitoring unit).
Remedy
 Carefully warm up the engine until the warning
light goes out.
 Top up the hydraulic oil.
 Call Customer Service.
 Call Customer Service.
 Release the parking brake.
 Top up the fuel.
 Vent the fuel system if the tank was run dry.
 Have the device serviced by Customer Service.
a The service display must be reset by Customer
Service.
 Perform regeneration (see chapter "Regenera-
tion").
 Call Customer Service.
km/h
km/h
km/h
km/h
%
m
-
V
Ah
mm
mm
mm
kg
kg
kg
kg
kg
kg
kg
English
20, 25, 30, 40, 50, 60
The speed may be limited de-
pending on the variant and
country specific requirements.
The limitation is secured by
software.
20
20
40 / winter
25
2,06 (Dwi)
Maintenance-free
12
105
4.248 +/- 30
1.300
1.990 +10/-20
2500-2800
(depending on the equipment
as a tractor)
6000
2700
3300
300
3000
750
69