Additional Operating Safety Instructions; Position Of Factory Nameplates; Chassis Number Position (Vin) - Kärcher MC 250 Mode D'emploi

Masquer les pouces Voir aussi pour MC 250:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 71
● Adhere to the safety checks according to the applicable
local regulations for mobile commercial vehicles.
● Do not clean the tyres, radiator fins, hydraulic hoses and
valves, seals, electrical and electronic components us-
ing a high-pressure cleaner.
● Pay attention to the correct tyre inflation pressure, an
excessively high tire inflation pressure can cause the
tyre to burst.
● Only original Kärcher seats may be used. Otherwise the
vibration values cannot be guaranteed.
4.7

Additional operating safety instructions

General
The vehicle has a hydrostatic drive, 2-wheel steering and
a selectable 4-wheel steering. It therefore exhibits driving
characteristics that are different to those of a car.
Braking characteristics
The brake pedal must be pressed in order to brake.
Note
Releasing the accelerator pedal provides no noticeable
braking effect.
Steering characteristics
The vehicle has 2-wheel steering and selectable 4-wheel
steering.
The 2-wheel steering is activated by default when starting
the vehicle (driving mode).
The 4-wheel steering can be selected as desired (working
mode).
The 4-wheel steering allows a tighter cornering than with
2-wheel steering.
Note
Avoid fast steering movements and drive slowly in bends.
Take the swinging at the rear into account.
Centre of gravity / pendulum characteristics
Rear attachments and load statuses influence the vehicle's
centre of gravity and the driving characteristics. You must
be ready to adjust to changed driving characteristics, par-
ticularly after changing attachments and in the case of
changeable load statuses. Limit ranges may be reached
earlier.
40
4.8

Position of factory nameplates

Note
The factory nameplates are in the direction of travel on the
right, inside the driver cabin next to the driver's seat.
1 Frame factory nameplate
2 Vehicle factory nameplate
3 Engine factory nameplate
4 Driver's seat
4.9

Chassis number position (VIN)

Note
The chassis number is located on the right side of the
frames in the direction of travel, in the area of the front
wheel.
1 Chassis number
English

Publicité

Table des Matières
loading

Table des Matières