Fuses; Fuses In The Cab; Fuses On The Vehicle - Kärcher MC 250 Mode D'emploi

Lock
1
Right side panel
2
Air-conditioner condenser
3
Combination cooler
4
Charge air, water and hydraulic oil cooler
–
1. Release the side panel lock with a square wrench.
2. Tilt the panel outwards, a safety rope holds it in position.
3. Manually remove coarse dirt from the radiator.
4. Use a soft brush or broom to clean with compressed air
(5 bar max.) or low water pressure.

14.9 Fuses

14.9.1Fuses in the cab

The fuses in the driver's cab are located behind a cover on
the middle rear wall of the cab.
Cover
1
Locks
2
Fuses
3
Diagnostic connector
4
1. Fold the passenger seat backrest forward.
2. Open the cover latches then tilt the cover and remove it
upwards.
3. Replace defective fuses.
Note
Use only fuses with the same ampere rating.

14.9.2Fuses on the vehicle

The next fuses are located on the vehicle behind a cover
on the right side panel.
Right side panel
1
Cover
2
Fuses
3
1. Release the side panel lock with a square wrench.
2. Tilt the panel outwards, a safety rope holds it in position.
3. Open the cover latch and remove the cover.
4. Replace defective fuses.
English 67