EdilKamin Evolution SOLEIL Installation, Usage Et Maintenance page 34

sk tecnica soleil-polaris-tania multilingua_vers E 03 05 2011.qxp 03/05/2011 16.36 Pagina 35
Covering assembly - POLARIS
INSTRUCTIONS FOR USE OF MATERIAL
KIT
The material kit supplied with the documentation is composed
of:
4 M6x12 screws
4 silicone spacers for top
8 flat washers diam. 6
Detail "X"
Instructions for use:
1. the 2 M6x12 screws and 2 M6 flat washers are for fixing the
2 Screws
upper front panel in stone.
2. the 2 M6x12 screws and 2 M6 flat washers are for fixing the
lower front panel in stone.
3. follow the sequence described below to fit the 4 spacers and
washers:
• insert the 4 stone spacers into the 4 free holes on the cast iron
top
• rest the stone top on them to check that it is level
• if necessary insert a flat washer between the silicone spacer and
the cast iron top so that the stone top is level with the stove.
The stove is delivered pre-assembled, however the covering can be removed if needed
by following the procedure described below:
Unscrew the back (80) and the two profiles (6), remove the cover (33), the cast iron top
(30) and the ceramic top (32).
Remove the stone side pieces (102-103-104) and if necessary remove the two alumi-
nium profiles (98) wedged into the base pins.
Remove the front profile (19) then remove the upper rear panel (24) from the fittings in
the grille structure.
To remove the lower front panel (105) unscrew the two screws see detail "X".
Follow the same procedure in reverse order to reassemble the stove.
34