Electronic Circuit Board; Electrical Characteristics; Safety Devices - EdilKamin Evolution SOLEIL Installation, Usage Et Maintenance

sk tecnica soleil-polaris-tania multilingua_vers E 03 05 2011.qxp
THERMOTECHNICAL CHARACTERISTICS
Hopper capacity
Efficiency
Max. heat output
Autonomy (min/max)
Fuel consumption (min/max)
Heatable volume*
Weight SOLEIL including packaging**
Weight TANIA including packaging**
Weight POLARIS including packaging** 296/302
Smoke outlet pipe diameter (male)
Air intake pipe diameter (male)
* The heatable room dimensions are calculated on the basis of
pellets with a lhv of at least 4300 kcal/kg and home insulation
in compliance with Italian law 10/91, and subsequent changes
together with an expected heat output of 35 Kcal/m³ per hour.
It is also important to consider the location of the stove in the
room to be heated.
** basis/channelled
The data shown above is purely indicative.
EDILKAMIN s.p.a. reserves the right to make changes
to these products to improve their performance with
no prior warning.

ELECTRICAL CHARACTERISTICS

Power supply
On/off switch
Average power consumption
Power consumption during ignition
Remote control frequency (standard)
Protection on mains power
supply*
Protection on electronic circuit board

SAFETY DEVICES

THERMOCOUPLE: placed at the smoke outlet to
detect the temperature. Turns the stove on and off and
controls its operation based on defined parameters.
AIR FLOW SENSOR: installed at the intake duct, it
trips when the flow of combustion air is not correct,
which causes low pressure problems in the smoke circuit.
SAFETY THERMOSTAT: trips when the temperature
inside the stove is too high. It stops pellet loading, causing
the stove to go out.

ELECTRONIC CIRCUIT BOARD

29 kg
89,1 %
12 kW
11/23 hours
1,3/2,7 kg/h
m ³
315
282/288 kg
267/273 kg
kg
80 mm
40 mm
SERIAL PORT
The Dealer can install an optional
on the AUX outlet (clean contact
on the pins) for controlling the
process of switching on and off
230Vac +/- 10% 50 Hz
(e.g. telephone remote, local thermostat), located at the
rear oh the stove. Can be connected via special optional
Yes
trestle (code 621240).
100 W
BACKUP BATTERY
400 W
A backup battery is found on the control board (3-Volt CR
Infrared
2032 battery). Its malfunction is indicated with the follo-
wing messages: (not considered a defect but due to nor-
2A, 250 Vac, 5x20 Fuse
mal wear-and-tear): ERROR RTC CD. For more detailed
information, please contact the DEALER who has perfor-
2A, 250 Vac, 5x20 Fuse
med the first 1st ignition.
FUSE
* two fuses are inserted in the socket with switch,
located on the back of the stove, one of which
operational and the other is held in reserve.
31
03/05/2011 16.36 Pagina 32
RPM VENTILA-
RPM VENTILATION
AUX TION AMBIENT
CHANNELLED
SMOKE RPM
PANEL CONTROL
Service
DAMPER
backup battery
SMOKE SCREW
EXPULSION
MOTOR
VENTILATION
VENTILATION
CHANNELLED
AMBIENT
FLOW SENSOR
SENSOR AIR
AMBIENT
230 Vac POWER
SUPPLY
2A FUSE
PORT BACK STOVE
pin 6
pin 2