Electronic Circuit Board; Safety Devices; Backup Battery - EdilKamin FLEXA Installation, Usage Et Maintenance

ELECTRONIC CIRCUIT BOARD

SMOKE VENT. ENCODER
PRESSURE TRANSDUCER
NTC 300°C PROBE
ENV. PROBE
*
ANCILLARY THERMOSTAT
SMOKE PROBE

SAFETY DEVICES

THERMOCOUPLE:
placed at the smoke outlet to detect the temperature. Turns the
stove on and off and controls its operation based on defined
parameters.
AIR FLOW SENSOR:
placed in the air inlet channel. This intervenes if an anomaly
is detected in the combustion air flow and causes insufficient
circulation in the smoke ducts.
SAFETY THERMOSTAT:
trips when the temperature inside the stove is too high.
It stops pellet loading, causing the stove to go out
(see alarm A09 on pg. 29).
ELECTRONIC EQUIPMENT
CONSOLE AND ACCESSORIES
ADD-line carrier
SERIAL
SENSOR LEVEL PELLET
INLETS
BACKUP
BATTERY
EXCHANGER
2
CONTACT
SECURITY
SCREW
ENTRY
SECURITY
SCREW
VOLUME METER
DISPLAY
EXCHANGER
SCREW
ALLARM
ALLARM
2 1
1
SMOKE
PLUG
VENTILATOR
REMOTE IGNITION
On the circuit board, there is an input)
supplementary thermostat clean contact *) that can be used for
remote ignitions via external thermostats.
These devices must be installed by authorized CAT via an
optional cable, code 640560.

BACKUP BATTERY

A backup battery is found on the control board (3-Volt CR
2032 battery).
For more detailed information, please contact the DEALER
who has performed the first 1st ignition.
- 27
-
FAN CONTROL
BOARDS
EXCHANGER
3