Electrical Connection - Iberspa SM-USO Manuel D'utilisation Et D'installation

ATTENTION
During the filling process, water should be prevented from entering electrical
parts. If seawater is used in the Spa, the circuit components will quickly
deteriorate.
Do not fill the Spa with hot water, as this could trigger off the safety thermostat
and damage equipment and connections.
Once the Spa has been filled with water, connect the electrical equipment by placing the
differential switch in the On position (See Electrical Connection).
Do not use the Spa without first carefully reading all the information detailed in the
following points:
• Adjust water ph between 7,2 and 7,6 (see 4.0 section).
• Add all required chemical products recommended in water maintenance (see 6.2 section)
• Select the required temperature (see Installation and assembly of the spa). remember
that if the water is cold, it may take 24 hours to reach a temperature of 38ºc.
• Before using the spa, check the ph values once again in case they have changed with
the treatments indicated above.

3.5. Electrical connection

ATTENTION
• This equipment cannot be connected to a normal plug.
• This equipment requires suitable electrical installation. This should be
done by a specialised fitter following local electrical safety regulations of
each country.
• The electrical input of the Spa should always be protected by a highly
sensitive differential. A 30 mA differential is recommended.
• Earthing connection is essential.
• Use a suitable section cable bearing in mind the power of the Spa and
distance to the control panel.
• Always follow instructions given in the Safety Warnings chapter of this
manual.
22