Installation And Assembly; Warnings; Position And Location Of The Spa; Outdoor Installation - Iberspa SM-USO Manuel D'utilisation Et D'installation

ENG

3. INSTALLATION AND ASSEMBLY

3.1. Warnings

• During the electrical conexion with the equipment have special care in the layout of the
cables in the bypass box, make sure no pieces of cables are in the box after closing and
that the ground conexion is correctly done.
• Pay special care that no water enters in conctact neither with the pumps neither with the
electrical parts under tension.

3.2. Position and location of the spa

Before installing and assembling the Spa, ensure that the packaging of the Spa is in
perfect condition. Contact your distributor immediately if the packaging is damaged.
Position the Spa horizontally, placing the whole base of the unit on a smooth, flat and
level surface, capable of supporting the weight when used (full of water, plus the weight
of the bathers).
The Spa cannot be placed on a curved surface or on blocks.
The side where the motors are located should be fully accessible. In order to carry out
maintenance tasks, the location of the Spa should enable it to be moved so that all its
sides can be easily accessed.
201

OUTDOOR INSTALLATION

If an outdoor location is chosen to place the Spa:
Do not expose the Spa to sunlight when it is empty and without a protection cover.
Remember that prolonged exposure to sunlight may damage the surface of the Spa
and its accessories. Acrylic rapidly absorbs heat from the sunrays reaching very high
temperatures which will damage the Spa. Maximum absorption temperature is 60ºC.
001
15