Pre-Filter Of The Pump Maintenance; Acrylic Maintenance - Iberspa SM-USO Manuel D'utilisation Et D'installation

SKIMMER FILTER CLEANING
1. Disconnect the electrical equipment. Differential in OFF position.
2. Pull the top of the skimmer.
3. Remove the cartridge.
4. Clean the cartridge with water at low pressure.
ATTENTION
Remember to follow all the steps and to close the valve in order not to damage
the Spa or hurt yourself.

6.4. Pre-filter of the pump maintenance

It is recommended to periodically check the condition of the pre-filter of the pump to
avoid it from blocking. If debris has accumulated, the pre-filter should be opened and
cleaned.
Follow these steps to clean the pre-filter:
1. Turn off the Filtering Pump by placing the selector in the OFF position.
2. Close the valve of the filtering circuit that connects the pump to the Spa.
3. Using the key supplied with the equipment, turn the upper cover of the pre-filter
anticlockwise until it becomes loose. Remove the basket of the pre-filter to clean it.
4. Put the basket back into place. Place the joint of the cover to close it using the key.
5. Open the filtering circuit valve.

6.5. Acrylic maintenance

Easy care for an elegant surface:
• Use common cleaners for general use. For normal care and cleaning, use a soft cloth
or sponge with a little soap and water. Rinse it well, and dry with a clean, dry cloth. If you
are using a household cleaner, please ensure it is recommended for acrylic surfaces by
the manufacturer.
• Never use abrasive cleaners.
• Do not allow the acrylic surface to come into contact with ketones or esters such as
acetone, acetates (such as nail varnish remover, nail varnish or dry cleaning substances)
or any organic solvent with chlorine, varnishes, petrol, aromatic solvents, etc.
ENG
039
53