Systems - Iberspa SM-USO Manuel D'utilisation Et D'installation

• The appliance should be installed through a residual current device (RCD) with a rated
tripping current not exceeding 30 mA
• The cover is designed to protect the spa, not to bear weight. Not even water or snow. Do
not place objects on top of the cover. Do not allow people or animals get on the cover.
Periodically remove snow to prevent buildup.
• The water should be disinfected thoroughly before using the Spa, especially if it has not
been used for a certain period of time, whether or not it has been left with or without water
inside. During periods of non-use, traces of stagnant water may remain, which may cause
the growth of micro organisms potentially dangerous for health. Therefore, disinfect the
Spa as indicated in this manual, ensuring that the pH and disinfectant parameters are
suitable.
ATTENTION
The compensation tanks of private overflow spas have a limited capacity.
They can hold 280 litres of water, equivalent to 4 partially submerged people.
Users should enter the spa one by one and slowly to enable the tanks to
absorb the displaced water and prevent water from flowing out of the spa.
RISKS OF HYPERTHERMIA
Prolonged, direct contact with hot water could cause hyperthermia.
This occurs when the internal body temperature reaches levels above the normal
temperature of 36.5ºC. It is advised not to bathe for longer than 15 minutes.
Symptoms of hyperthermia are a sudden drop in blood pressure resulting in a sensation
of dizziness with the possibility of fainting.
Water temperatures between 37ºC and 40ºC are only considered safe for adults without
any health problems. Lower temperatures are recommended for the majority of people
and children. The Spa water should never be above 40ºC.
WARNING
Alcohol, drugs or medicines could increase the risk of hyperthermia.
It is not advisable for pregnant women, patients with high blood pressure, a
heart condition, diabetes or under medication to use the spa. You should seek
doctor's advice.

5.2. Systems

EXISTING SYSTEMS
Your spa is equipped with an electronic control system that will enable you to regulate the
temperature of the water, choose the filter cycle that best suits your needs and activate
the massage pumps and the blower pump. It will also enable you to turn on your spa
lighting, change its colour and sequence. Depending on the design, your spa will have
one of the following systems:
32