Iberspa SM-USO Manuel D'utilisation Et D'installation page 57

Sensor A Fault, A temperature sensor or sensor circuit
has failed.
Senor B Fault –
Sensor A: M031,
Sensor B: M032
Comunications The control panel is not receiving
communication from the System.
error
Test software The Control System is operating with test
software.
installed
Program At Power-Up, the system has failed the
Program Checksum Test.
memory failure
– M022
The settings
have been reset
(Persistent
Memory Error)
– M021
The clock has
failed – M020
Configuration
error (Spa will
not Start Up)
A pump may Water may be overheated.
be stuck on –
M034
Hot fault – A Pump Appears to have been Stuck
ON when spa was last powered POWER
M035
DOWN THE SPA.
** Some messages can be reset from the panel. Messages that can be reset will appear
with a Clear Icon at the bottom of the Message Screen. Press the Clear Icon text to reset
the message.
If the problem persists, contact your vendor or a
service engineer.
See: **.
If the problem persists, contact your vendor or a
service engineer.
If the problem persists, contact your vendor or a
service engineer.
This indicates a problem with the firmware (operation
program) and requires a service call.
See: **.
Contact your service organization if this message
appears on more than one power-up.
See: **.
If the problem persists, contact your vendor or a
service engineer.
See: **.
If the problem persists, contact your vendor or a
service engineer.
POWER DOWN THE SPA. DO NOT ENTER THE
WATER. Contact your dealer or service organization.
DO NOT ENTER THE WATER.
If the problem persists, contact your vendor or a
service engineer.
ENG
57