Iberspa SM-USO Manuel D'utilisation Et D'installation page 55

PROLONGED PERIODS (5-14 days)
• Set the temperature at its lowest level.
• Adjust the pH and treat the water (see Water Maintenance section).
• Cover the Spa.
• Before using the Spa again, reset the temperature as required , readjust the pH and treat
the water again.
PREPARTING FOR THE WINTER PERIOD
If it is not planned to use the Spa through the winter season or for prolonged periods of
time, the following operations should be done:
• Disconnect the electrical equipment, placing the differential switch tab in the OFF
position.
• Locate the drain valve (see Drainage of the Spa) and turn the red lever of the valve to the
OPEN position. The Spa will empty by gravity through the general drain.
• Leave the drain valve open.
• Remove the filter cartridge/s from the filter (See Maintenance of the filter) and keep in
a dry place.
• Clean and dry the Spa.
• Cover the Spa.
Do not leave water in the Spa without electrical connection at temperatures below 0ºC, as
the pipes can freeze and damage the spa.
ATTENTION
Remember that when you drain your spa not all of the water runs off. If your
spa is not going to be used for long periods, especially in winter, remove any
stagnant water on the seats and on the bottom of the spa with a sponge.
Any water remaining in the pipes can be sucked out through the water and
air nozzles using a liquid suction pump. The pumps must also be emptied
through the drain plug.
ENG
55