Filling The Spa - Iberspa SM-USO Manuel D'utilisation Et D'installation

3.4. Filling the spa

PORTABLE SPA
The Spa does not have a specific filling system. It is recommended to use a manual filling
system with a garden hose or similar.
Proceed as follows:
• Before starting filling the Spa, locate the drain valve (see 3.3. Drainage) and ensure that
it is in the CLOSED position.
• Fill the Spa through the top, with clean water, to the level indicated.
WATER LEVEL
100mm
PORTABLE OVERFLOW SPA
It is recommended to fill the spa manually using a garden hose or a similar system.
Proceed as follows:
Before filling the spa, find the drainage valves and ensure they are all closed, except for
the safety outlet, which should always be open.
Fill the spa from above using clean water until the spa starts to overflow.
Fill the three water tanks with the automatic filling.
Connect the water supply to one of the tanks' inlets.
The spa has a filling system that works using a ball cock. The outlet of the ball cock must
be connected to the mains supply at a constant water pressure.
When the spa loses water as a result of evaporation, the system automatically fills the
tanks.
The compensation tanks have a safety outlet for removing water.
WARNING
The compensation tanks of private overflow spas have a limited capacity.
They can hold 280 litres of water, equivalent to 4 partially submerged people.
Users should enter the spa one by one and slowly to enable the tanks to
absorb the displaced water and prevent water from flowing out of the spa.
010
ENG
=
=
011
21