Safety In The Use Of Chemical Products - Iberspa SM-USO Manuel D'utilisation Et D'installation

avoid freezing conditions not detected by the standard sensor.
If the pump turns off in this situation, empty the Spa and contact your authorised dealer or
Technical Assistance Service.

SAFETY IN THE USE OF CHEMICAL PRODUCTS

Before using a chemical product, read the instructions on the product label carefully.
• It is advisable that always the same person handles the chemical products. Keep these
products away from children.
• Add the exact amounts to the water, as specified.
• Keep containers tightly closed in dry, well-ventilated places.
• Do not inhale chemical products, and take care not to let them come into contact with
the eyes, nose or mouth. Wash hands after use.
• Follow the emergency instructions on the product label in the event of an accident or
ingestion.
• Do not smoke while handling these products – they may be flammable.
• Do not store these products inside the Spa unit.
• Do not mix products. Add first one and then the other to the water, to avoid possible
reactions.
• Do not add chemical products to the water if there is someone in the Spa.
MAINTENANCE SCHEDULE OF THE SPA WATER
All chemical products: Bromine in tablet form, Algaecides, Anti-calcareous and pH
reducer, must be added to a floating dispenser (not supplied), with the massage pump on
for at least ten minutes.
pH ADJUSTMENT
A pH index of between 7.2 and 7.6 is recommended.
The pH level measures the acidity and alkalinity: Values above 7 are alkali and below 7,
are acid.
ATTENTION
It is very important to maintain the correct pH level both for the disinfectant to
work properly and to prevent corrosion or deposits on the Spa. Any damage
caused by an inadequate pH level is not covered by your Spa guarantee.
ENG
49