Swimspa Controls; Renewing The Spa Water - Iberspa SM-USO Manuel D'utilisation Et D'installation

5.4. Swimspa controls

A - Jetstream control
With the jetstream control you can choose the power of the bottom jetstream and
the massage.
B – Fountains control
Turning the fountains control you can regulate the flow of the three fountain jets. The
fountain only runs when the filtration circuit is running or the spa is in heating process.
C – Main control panel
With the electronic main control panel you can turn on or turn off the Jets, Blower
(optional) and Light, set the Temperature, the filtration cycles and Time.
D – Air control
With the air input valve you can adjust the air turbulence of the jetstream.
E – Jetstream control
With the jetstream control you can choose the power of the top jetstream and the
massage.

5.6. Renewing the spa water

To change the Spa water:
• Disconnect the electrical equipment, placing the differential switch (installed in the main
input of the home) in the OFF position.
• Locate the drain valve (see 3.3 Drainage) and turn the valve to the OPEN position. The
Spa will empty by gravity through the general drain.
• Once the Spa is empty, inspect the acrylic and clean if necessary (see point 6.5 Acrylic
Maintenance). Turn the drain valve to the CLOSED position.
• Fill the Spa with clean water (see 3.4 Filling the spa)
42
A B C D E
030