Indoor Installation - Iberspa SM-USO Manuel D'utilisation Et D'installation

It is recommended to place the Spa away from trees, as falling leaves may block the filter.
If the Spa is placed inside glass structures, prevent sunrays shining directly on the Spa
through the glass, as the temperature could be excessively hot.

INDOOR INSTALLATION

It is recommended to ensure drainage in the area of the Spa, to prevent water from
accumulating around it and to avoid dangerous access areas for bathers.
Remember that the operation of the Spa causes increased damp and therefore, there
must be a ventilation system to prevent damp from accumulating which could cause
damage in the room where the Spa is located.
The use of a cover reduces heat loss and damp in the room.
ATTENTION
The spa should not be left empty and uncovered at room temperatures over
20ºC or below 4ºC.
PORTABLE LEVELLING SPAS
Some spas come with an adjustable metal structure to facilitate their installation. This
structure has several points of support. Before filling the spa, these points of support
should be adjusted to ensure they are all in contact with the ground.
16
002