Light Maintenance; Maintenance In Periods Of Non-Use Or Absence - Iberspa SM-USO Manuel D'utilisation Et D'installation

• Remove dust, smears and dry dirt with a soft, moist cloth.
• Clean off grease, oil, paint and ink stains with isopropyl alcohol and dry it with a clean,
dry cloth.
• Avoid using razors or any other kind of sharp instrument that could scratch the surface.
Small scratches can be removed by applying a fine layer of automotive varnish and lightly
polishing it with a clean cloth.
Once a week, clean the area of the Spa which is not underwater with a quality polish for
Spas.
ATTENTION
Remember to never leave the Spa uncovered and exposed to sunlight, as this
could cause damage not covered by the guarantee.

6.6. Light maintenance

Replacing the lamp is the only required maintenance on the spotlight. To replace the
lamp, follow these steps:
• Dismantle the wooden side panel where the spotlight is installed using a medium-sized
stecker screwdriver.
• To replace the lamp, turn the lamp-holder bushing anticlockwise and lift it from its
position.
• Once the faulty lamp has been replaced, place the lamp-holder back in position and
reassemble the wooden side panel of the Spa.
If you have any doubt about the explanation of this operation, contact your authorised
dealer or authorised technical service.
WARNING- RISK OF ELECTRIC SHOCK
Make sure the power of the Spa is turned off.
The new lamp must have the same features as the lamp supplied.
Never install lamps without the front lens.
To ensure perfect watertightness, clean the mounting base of the flat gasket
of the glass or replace it if you observe any dents or permanent damage.

6.7. Maintenance in periods of non-use or absence

SHORT PERIODS (3-5 days)
• Adjust the pH and treat the water (see Water Maintenance section).
• Cover the spa.
• Before using the Spa again, readjust the pH and treat the water again.
54