Iberspa SM-USO Manuel D'utilisation Et D'installation page 25

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 116
A6 Persistent memory reset (Used when the spa is powering up to restore factory
settings as
determined by software configuration).
A2, A3 and A4 work in combinatio to determine the number of high-speed devices
and blowers that can run before the heat is disabled. f.e. A2 and A3 in the ON position
and A4 in the OFF position will allow the heater to operate with up to 3 high-speed
pumps (or two HS Pumps and Blower) runing at the same time. Heat is disabled when
the fourth high-speed pump or blower is turned on.
Note: A2/A3/A4 all ogg = No heat with any high-speed pump or blower.
Assignable DIP Switches
A7 In "ON" position, enables a 5-minutes cool down for some gas heaters (Cooling
Time B). In "OFF" position, enables a 1-minute cool down for electric heaters (Cooling
Time A).
Undesignted switches are not assigned a function.
The Electric Specification Sheet attached at the end of this manual indicates both the
"Low Amp" and the "High Amp" power.
Special Features
CABLE SECTION
To determine the cable section of the electrical installation, see the values indicated
in this sheet and the following table:
2,1
2,5
Distance
6 - 11 m
2,5
2,5
11 - 15 m
2,5
2,5
15 - 20 m
4
For longer distances, increase the cable section accordingly.
Some configurations may require installing 1 32A line, 2 16A lines or even one three-
phase line (3 x 16A) to cover the power required by the Spa.
The different configuration options of the electrical control panel are explained
further on in this Installation Manual.
Remember that the installation and any changes in the electric configuration must be
carried out by qualified personnel, following the current regulations in each country.
The manufacturer shall not be responsible for any damage caused by an improper
installation or an installation performed by non-qualified personnel.
KW required
2,8
3,2
3,5
Nominal section of the cable in mm
2,5
2,5
4
4
4
4
4
4
6
6
4,4
5,3
6,2
7,0
2
4
6
10
10
6
6
10
10
6
10
10
10
ENG
015
7,9
8,8
10
10
10
10
16
16
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ins-pr

Table des Matières