Start-Up; System Start-Up; Pre-Set Filter Cycles - Iberspa SM-USO Manuel D'utilisation Et D'installation

4. START-UP

4.1. System start-up

Check the following configurations before using your spa depending on your spa system:
· TP-600
TEMPERATURE CONFIGURATION
When using a panel with Up and Down buttons (Temperature buttons), pressing Up
or Down will cause the temperature to flash. Pressing a temperature button again will
adjust the set temperature in the direction indicated on the button. When the LCD
stops flashing, the spa will heat to the new set temperature when required.
If a Temperature button is pressed and held when the temperature is flashing, the
temperature will continue to change until the button is released.

PRE-SET FILTER CYCLES

Main Screen
To next item in
Main Menu
28
| TP600
| TP600
While the Temperature is still
flashing, press Light repeatedly
until MODE appears in the LCD.
Shows/flashes start time
to show RUN HRS
to show F1 ENDS xx:xx
To Set
To Set
Shows/flashes start time
to show RUN HRS
to show F1 ENDS xx:xx
Sets start hour
Selects minutes
Sets Filter 1 length in hours Selects part of an hour
To Set
*****
Waiting several seconds will lose
any new Filter 1
Start Time and Run Hours and revert
to the previous Filter 1 settings.
Main Screen
Waiting
Several Seconds
Reverts to Original Setting
*****
To Set
Selects minutes
Sets start hour
Sets Filter 2 length in hours
Selects part of an hour
To Set
*****
Waiting several seconds will lose any
new Filter 2 On/OFF,
Start Time and Run Hours and revert
to any previous Filter 2 settings.
Sets 15-minute increments
Waiting
Several Seconds
Reverts to Original
Setting
*****
Sets 15-minute increments
Wait to Revert
*****
Waiting
Sets 15-minute increments
Several Seconds
Reverts to Original
Setting
*****
Sets 15-minute increments
*****
Main Sc r een
Main Screen